Different heating methods and heat media of the setting machine will make the reasonable utilization rate of mechanical equipment different, and the processing standards generated during the processing will also be different, which will lead to differences in the economic interests of the company. The feeding structure of the forming machine is relatively simple. It consists of a trough and a hot-rolled strip. The cloth enters the trough, and the chemical material is transported away, and then the hot-rolled strip is used to squeeze the remaining chemical material dry. Therefore, the application of chemical raw materials in the cloth is very uniform, which is a prerequisite for the production of high-quality mechanical equipment.
It is feasible for heat setting equipment to use gas as a heat medium for heating and setting, and various needs can be considered according to the development trend of production and manufacturing, because LPG or gas is expensive and unstable. From the point of view of economic development, when the gas heat-setting device is used, the gas is ignited in the heat-setting device to generate a high exhaust gas temperature, and the indoor space is relatively limited, so attention should be paid to the problem of waste heat recovery. The weapon equipment of the shaping machine adopts weft adjuster and relative sensor. Each sensor includes two parts: photosensitive and photosensitive. According to the photoelectric effect, the weft can be skewed to the cloth. In the hydraulic drive system, when the deflection manipulation data signal returns to the motherboard specification, the computer motherboard will announce the control code and the hydraulic drive system software.
The exhaust gas discharged from the setting machine contains a lot of fibers and oil stains, which are easy to adhere to the surface of the heat pipe during the heat exchange process, which is harmful to the heat convection. The machine is not working properly. When there is a common failure or blockage of the heat pipe machine equipment, it should be replaced and removed immediately to ensure the actual effect of the waste heat recovery of the heat pipe machine and prolong the service life of the heat pipe machine equipment. The setting machine has eight sets of drying boxes, and the gas is continuously sprayed into the nylon cloth from the aircraft frame in the actual effect through the transmission of the electric fan of the circulation system. After the hot air comes into contact with the wet cloth, it is heated by the heat exchanger according to the filter screen, and it is continuously recycled.
